Gate is Finished

I don't think there was enough work in mounting the gate to warrant video, so I'll just write the main points here.
The top hinge had to be raised by about 4 inches to line up with the crossledge on the gate. This is just mounted by four screws in to a mahogany stile.

I had to drill a one and a quarter inch hole through the gate and brace to mount the lock. Originally I was unsure whether a lock designed for indoor use would stand the test of time outdoors, but the lock is probably in it's 10 or 11th year now and with just a couiple of squirts of WD40 now and again it is working fine.

On top of the door I have mounted a strip of 2x1 as a rain guard for water running on to the end grain. The wood is rebated on the bottom about three eights of an inch so it overlaps on each side.

I have also fitted a small hook and hasp latch at the top of the door as extra security if the lock is on latch. This is because we have two dogs and the kids are always leaving the gate open.

Prior to mounting the gate I left it soaking at each end overnight in Cuprinol 5 Star wood preserve. This soaked up inside the door and hopefully will provide years of protection. The rest of the gate has had a liberal brushing of the same.

Next stage is to colour the gate with a mid brown stain called fencelife. This will have to be repeated each year as the stain faids in sunlight.


I mentioned in my last video that I used a homemade door stand for planing and working on the gate. In my next post I will show some photos and instruction on how to make this handy tool.

Ledge and Braced Garden Gate

Following my post earlier this week, here is the video showing how to make a simple ledge and braced garden gate. It's quite a long video but it covers all the relevent parts.
In a few days time I will be hanging the gate so I'll put that video up as well.
If you have any questions, drop me a line and I will help where I can.

Cross cut Saw (Foldaway)

Ok, I said in yesterday blog how important it is to 'save space' in your shed. When you are dealing with small spaces and lots of equipment, being able to 'knock them down' helps. These photos show you just how I achieve that with my cross cut saw. The saw is an electra beckum that is quite weighty (about 22kg)So to keep getting this out and putting it away daily is just not a practical option.
I mounted the saw on a piece of 16mm MDF that I hinged to a batton on my shed wall. At the front of the base I drilled a hole that accepts a 10mm dowel, I drilled a similar hole directly underneath in the wooden floor. Between the two is a length of 2" square wood that when fit keeps the table perfectly horizontal.
Tomorrow I will show you how I create the same effect with a router table.